This website will be unavailable from Thursday, May 30, 2024 at 6:00 p.m. through Monday, June 3, 2024 at 7:00 a.m. due to data center maintenance.

  85R12783 PAM-D
 
  By: Gervin-Hawkins H.B. No. 3349
 
 
 
A BILL TO BE ENTITLED
 
AN ACT
  relating to creating an abbreviated certification program and a
  certificate for trade and industrial workforce training.
         BE IT ENACTED BY THE LEGISLATURE OF THE STATE OF TEXAS:
         SECTION 1.  Subchapter B, Chapter 21, Education Code, is
  amended by adding Sections 21.0442 and 21.0491 to read as follows:
         Sec. 21.0442.  EDUCATOR PREPARATION PROGRAM FOR TRADE AND
  INDUSTRIAL WORKFORCE TRAINING CERTIFICATE. (a) The board shall
  propose rules under this subchapter to create an abbreviated
  educator preparation program for a person seeking certification in
  trade and industrial workforce training.
         (b)  Subject to Subsection (c), a person is eligible for
  admission to an educator preparation program created under this
  section only if the person:
               (1)  has been issued a high school diploma;
               (2)  has 10 years of full-time wage-earning experience
  within the preceding 12 years in an approved occupation for which
  instruction is offered; and
               (3)  holds with respect to that occupation a current
  license, certificate, or registration, as applicable, issued by a
  nationally recognized accrediting agency based on a recognized test
  or measurement.
         (c)  The board may propose rules under which a person is
  eligible for admission under Subsection (b) if the person has five
  years of full-time wage-earning experience within the preceding
  seven years in an approved occupation for which instruction is
  offered if the person holds an advanced license, certificate, or
  registration, as applicable, issued by a nationally recognized
  accrediting agency. 
         (d)  In proposing rules for an educator preparation program
  under this section, the board shall ensure that the program
  requires:
               (1)  instruction in:
                     (A)  a specific pedagogy;
                     (B)  classroom management; and
                     (C)  relevant federal and state education laws;
  and
               (2)  at least 25 hours of instruction and not more than
  50 hours of instruction.
         Sec. 21.0491.  TRADE AND INDUSTRIAL WORKFORCE TRAINING
  CERTIFICATE. (a) To provide a continuing additional source of
  teachers to provide workforce training, the board shall establish a
  trade and industrial workforce training certificate that may be
  obtained through an abbreviated educator preparation program under
  Section 21.0442.
         (b)  To be eligible for a certificate under this section, a
  person must:
               (1)  satisfactorily complete the course work for that
  certificate in an educator preparation program under Section
  21.0442;
               (2)  perform satisfactorily on a trade and industrial
  workforce training certificate examination prescribed by the
  board; and
               (3)  satisfy any other requirements prescribed by the
  board.
         SECTION 2.  The State Board for Educator Certification shall
  propose rules:
               (1)  establishing requirements and prescribing an
  examination for a trade and industrial workforce training
  certificate examination as required by Section 21.0491, Education
  Code, as added by this Act; and
               (2)  establishing standards to govern the approval and
  renewal of approval of educator preparation programs for
  certification in trade and industrial workforce training.
         SECTION 3.  This Act takes effect immediately if it receives
  a vote of two-thirds of all the members elected to each house, as
  provided by Section 39, Article III, Texas Constitution.  If this
  Act does not receive the vote necessary for immediate effect, this
  Act takes effect September 1, 2017.